Remove detergent dispenser drawer, unscrew 3 x torx 20 screws around detergent dispenser opening. Remove machine lid with no.2 phillips screws on lr side of machine top. Two spade connectors and crimp tool lubricant to ease the the pump into the base. Only required cutting off the plug and fitting connectors for spades on pump. Unbolted shock dampers, bolted in new onesįitting is easy enough - only change was the plug in connection. Make sure it cannot fall back as it is very heavy. allowed door to be opened with water still in the drum.Īccess from underneath after tilting machine. Move water inlet valve to the right and remove from machineĢ1% Banging badly when out of balance load caused water level detector to stop operating as tube was damaged. Remove single securing screw for water inlet valve located on back face of machine 6. Pull off connection plug to water inlet valve solenoids board 5. Loosen hose securing clips to water dispenser 4. Water off and disconnect inlet water hose to machine 3. Pliers, 7mm spanner, screwdriver to take off machine top coverĮeasy to fit. ![]() Screwdriver and pliers to undo hose clampsĪfter removing top cover of machine unscrew water inlet hose, remove inlet valve by unscrewing little bolt (7mm spanner) and disconnect 3 hoses. Get your son who is an air conditioning mechanic -that makes it easier especially when there is electronic switches involved -although I feel I could of done it as well. remove three water hoses and unscrew water inlet hose.
0 Comments
Leave a Reply. |